U CUP Hydraulic Oil Seal Kit Wheel Loader 1672307 3623819 1672294 3382444 3382445

1672307 3623819 1672294 3382444 3382445 SEAL U CUP parts WHEEL LOADER

BACKHOE LOADER 422E 422F 428E 428F 434E 434F
WHEEL LOADER 924K

BACKHOE LOADER 416F 420F 422F 428F 430F 432F

167-2294 - Seal-U-Cup 5J8150 fits ()
FIRST PRICE PARTS

5J8225 Seal U-Cup Fits 3623819
TCP Warranty

5J8225 - Seal-U-Cup 1672307 for ()
FIRST PRICE PARTS

Drain the water and the sediment from the settling tank daily. Ensure that the temperature of the settling tank is proper for the viscosity of the fuel oil.Fuel Storage Tanks

Put water temperature regulator (3) and gasket (2) in position on the cylinder head.
Put pipe (1) in position. The side with the plug faces the front of the engine. Install the four bolts that hold pipe (1) in position.

1. Excessive Idle or High Load
A. Use Electronic Technician (ET) to check the Current Totals for excessive idle time and/or for a high load factor. These factors would be indiive of poor operating habits.
Idle time or load
Result: The idle times or load was excessive.
Reduce idle times or load.
Result: The idle times or load was not excessive.
Proceed to Test Step 2.
2. Diagnostic Codes

772B ( 64W ) Tractors;
773B ( 63W ) Trucks;
3412 ( 81Z ) Generator Sets;
3412 ( 38S ) Industrial EnginesReference: Service Magazine; January 28, 1991; Page 4; "New One-Piece Exhaust Manifold Used."Description of Change: An improved exhaust manifold group will help eliminate stud breakage and exhaust leakage on 772B Tractors and 773B Trucks. The improved exhaust manifold has eliminated the individual section to each cylinder. This exhaust manifold group can also be used on 3412 Generator Set and Industrial Engines in extreme service appliions where stud breakage has occurred.

Illustration 1 g03564541
Sealed accumulator (typical example)
(A) 6.35 mm (0.25 inch)
(B) Drill loion
Using a 4.76 mm (3/16") drill bit (3), drill at a slow and even rate on the fluid side of the accumulator. The drill loion (B) is 6.35 mm (0.25 inch) (A) below the electron beam weld.
Allow all gas to deplete.